It's been too long since I lasted added a post to this blog. It seems Covid and the changes we all went through over the last few years has had an effect on my interest in writing. With the new year just beginning, I'm planning to add more posts without such a long stretch between.
As a quilting teacher, I've found that making small quilts as samples is very useful. They're much easier to store and transport. Many of them have become favorites that I display around our home, changing them out by season or theme. When I inventoried my quilts during 2020, I discovered I have over 70 wall-hanging size quilts!
Since we rarely change out the quilts on the beds, keeping the number of large quilts to a minimum also influences this trend of making small quilts. There are some quilts with sentimental value that come out on occasion. Some are strictly used as samples for classes or are part of trunk shows that stay in the various go-bags. But a majority of them are fun to pick from to display and also include in a recently added trunk show, "Think Small for the Wall" that is available in person or via Zoom. Around the house, my husband prefers that I not put more holes in the walls, so I've come up with some pretty cool and affordable ways to hang large and small quilts. Regardless of the size of the quilt, I nearly always add a hanging sleeve on each quilt. I do this not only to make it easy to hang them at home, but also to meet the requirements if I enter them in the county or state fair, or regional quilt shows that require sleeves. Even when I use them on the bed, having a sleeve on them doesn't make them any less useful as a quilt to cuddle or sleep under.
In our home, there is a long wall that extends from the front door in the living room to the back door in the kitchen. The doorway to the hall leading to the bedrooms is about in the middle. This entire space has a vaulted ceiling, so there is lots of high open space to display quilts! For these, we have two 80" long decorative curtain rods installed permanently and use custom PVC poles that my husband fashioned that we can easily lift the rods down and back up to change out the quilts. At our ages, getting on ladders to do so just isn't safe anymore, not to mention the furniture that is in the way of getting the ladders close enough to reach the rods.
My favorite way to hang most wall-hanging quilts involves block magnets, 5 lb Command strip refills, and steel strapping, all of which you can get at your local hardware store (think Home Depot, Lowe's, Menards, or Ace Hardware, etc.) and a couple of hair ties. At a quilt show several years ago I saw a product to hang quilts with magnets, but they were quite expensive! I was sure my husband and I could come up with an affordable way to do something similar. Our trip to the hardware store was successful indeed!
The first thing to do is cut the steel strapping in half. I've used both the 36" pieces for small to medium quilts and 48" pieces for the medium to large quilts. I wrap the ends with 2" wide blue painter's tape to keep the ends from snagging the quilt when it slides through the sleeve. I take two hair ties and double wrap the two pieces of strapping. The two bands keep the pieces straight and only when one of the bands breaks, which does happen on occasion after adjusting the width several times, does it cause a problem. The two bands allows me to adjust the width of the strapping pieces to fit the various quilts. For wider quilts they get stretched out, but always have an overlap with the two hair ties spaced out. When I hang the smaller quilts I slide the strapping pieces back together with the hair ties at the ends. It's nice to have them adjustable when swapping out wall quilts of different widths.
The next step is to clean the magnets with alcohol so they will stick
well to the Command Strips. I also clean the wall with alcohol where I'm
going to place the magnets. The 5 lb Command Strip refills seem to work
the best as they are designed to carry a heavier load. I place 3
magnets on the wall so the weight of the quilts is distributed to hold
them securely. I use a level to make small pencil marks for the
placement of each magnet to make sure they are straight across so my quilts
hang nicely. I leave the magnets, stuck to the wall with the Command
Strips, to set for ~24 hours to let the adhesive settle before I hang
the quilt. Once I'm ready to go, I slide the strapping into the sleeve and voila! The strapping grabs to the magnets through the sleeve and my quilt is instantly hung! And there are no holes in the wall!
Such great ideas! Thanks. I'll be heading to the hardware store soon ... ~Jeanne
ReplyDeleteThank you!
Delete